1.Inspect the machine：Ensure that all parts of the machine (such as rollers, cutting molds, etc.) are securely installed and that the power cord is intact. Clean the surface of the machine with a dry cloth to avoid dust or oil.
2.Prepare the dough：The dough recipe is given to the buyer at the time of purchase of the machine. Knead the dough until it is smooth and non-sticky. Cover with a damp cloth and leave for 20-30 minutes to make the dough softer.
3.Cut the dough：Roll the dough into long strips and cut it into small pieces for the machine to press and form.
1.Switch on：Power on the machine, click the switch, check whether the machine is turning, if reverse need to adjust the motor wire.
2.Debugging conveyor：Observe whether the conveyor belt deviates, if it deviates to one side, you can adjust the center by adjusting the handwheel.
3.Adjusting roll：Adjust the roll handle to the tightest, and then loosen back to ensure that the gap between the two rollers is consistent to control the thickness of dumpling skin.
1.Put in dough：Put the kneaded dough into the feed port, mainly do not push the dough directly by hand, so as to avoid danger.
2.Automatic production：Start the machine. After the dough passes through the roller and conveyor belt, it is automatically sprinkled with starch or dry flour and finally formed into dumpling skin by the mold roller.
1.Cleaning machine：After use, disassemble the machine parts, wash them thoroughly with water, and dry them for storage.
2.lubricating maintenance：Regular lubrication of mechanical components, such as chains, gears, etc., to extend machine life.
3.Long-term storage：If it is not used for a long time, it is necessary to apply cooking oil on the mold to prevent rust.
1.Safe operation：Avoid direct hand contact with the moving parts of the machine, especially rolls and conveyor belts.
2.Regular checking：Before each use, check the power switch, molding mold and other parts for foreign bodies to ensure the normal operation of the machine.
3.Fault handling：If the machine has abnormal sound or fault, it should be stopped immediately and contact the manufacturer for maintenance, do not remove it by yourself.
